We use cookies to give you the best customer experience possible. If you continue to use our web, we will assume that you agree to the use of such cookies.


Jawa parts shop in Zlin (CZ)


Introduction » MotoCare, Chemistry & Oils » Technical preparations » MOTIP - Engine paint, SILVER


MOTIP - Engine paint, SILVER



Product no.: 3551
Manufacturer: NL
Performance: 400 ml / Aerosol
Weight: 0,385 kg
Our Price without Tax : 12.40 EUR
Our Price including Tax (21 %):
15.00 EUR

into the basket:

Full specifications

MOTIP - Engine paint, SILVER

MOTIP - Engine paint can be used to coat engine blocks and other parts that have been exposed to strong vibrations and heat stress (up 110°C). The lacquer coating retains the required level of elasticity.


  • Good filling power
  • Long-lasting high gloss
  • Elastic, resistant to change in temperature
  • Scratch and shockproof
  • Good protection against corrosion
  • Dirt repellent
  • UV resistant
  • Excellent adhesion


  • Basis of the binder: alkyd resin
  • Colour: diverse
  • Smell: solvent
  • Degree of gloss (at measurement angle 60° acc. to DIN 67530):
    glossy: 90 glossy units
  • Efficiency:
    Depending on consistence and colour of the ground:
    400 ml are sufficient for approx. 1.25 - 1.75 m²
  • Drying time (at 20°C, 50% relative air humidity):
    Dust-dry: after approx. 30-60 minutes
    Tack-free: after approx. 3 hours
    Coatable: after approx. 24 hours
    The drying time depends on surrounding temperature, air humidity and thickness of the applied coat.
  • Temperature-resistant: up to 110°C
  • Maximum load: up to 150°C
  • Storage stability:
    10 years if appropriate storage provided (=10°-25°C, relative air humidity of max. 60%)
  • Size:
    aerosol can, maximum nominal volume 400 ml


Before use, carefully read and observe the warning texts on the label!


  • Remove rust and dirt.
  • Surface should be clean, dry and free of grease.
  • Cover area not to be treated with masking tape.
  • Shake can for 2 minutes before use.
  • Spray to test compatibility on an inconspicuous area.
  • Spray several thin coats crosswise from a distance of ca. 25-30 cm.
  • Do not spray on surfaces coated with synthetic resin!
Watch DOG

Inform via email when change of:

       when the price is lower than EUR

        when the product is on stock

Fill in your emaill: